Having a scratch on your car is dreadful. When they take place, they compromise the complete car’s paintwork. However, scratches are not the only eyesore; they can also reduce the worth of your vehicle. In many cases, restoration work performed by Stanmore spray painting professionals seems hugely costly. If you employ spray paint to cover up a scratch on your car’s paintwork, it will provide an efficient and inexpensive means of restoring your vehicle to its original look.
Let us have a look at the following easy and simple tips to make your car good looking
Things you need:
- Aerosol primer
- Factory-matched automotive paint in spray can
- 2 oz. wax and grease remover
- Masking paper
- 220 grit sandpaper
- Grey scuff pad
- Body filler & plastic spreader
- Automotive clear coat in a spray can
- Masking tape
Step 1- Clean as well as prepare the panel
Wash down the complete panel (door, fender, and hood) you are refurbishing with wax and grease remover. First, you need to clean with a wet towel and then next with a dry cloth. Scrape the whole panel with a grey scuff pad with average pressure.
Step 2: Fill & Sand scratches
Cover 220 grit sandpaper around a foam sanding block or your grey scuff pad. Next, you need to sand with hard pressure. However, if you look that all scratches do not get sand out, fill up them with body filler. Now, wait for 10 minutes so that filler gets hard and then sand with 220 grit sandpaper. Wait 5-10 minutes for the liner to harden, and then rub down with 220 grit sandpaper. A heat gun can pace up the hardening of the filler. You need to repeat this process three to four times.
Step: 3 Employ primer
Cover off the part of the panel that you have filled and sanded. Shake your primer can for 60 seconds and then apply various light coats of primer. After coating, wait for 20 minutes and then further wet sand with 600 grit sandpaper.
Step 4: Apply base coat paint
Disguise off the region with paper and masking tape. Quiver the spray can for about thirty seconds. Test your spray pattern besides a section of cardboard. Apply numerous lights coats of paint, from approximately 10 – 12 inches away. If you discover any imperfection, wait 5 minutes, and lightly sand out the defects with 600 grit sandpaper. In Stanmore spray painting for a silver or gold car is performed by observing stripes and then you need to pursue up with a few vertical passes.
Step 5: Apply Clear Coat Paint.
Wait at least 5 minutes once you have applied a clear coat. Make several light coats of clear coat so that it partly covers leave behind by about 50%. Wait 10 minutes, and eliminate your tape and paper.
Finally, you have completed your spray painting process for your car. Wash your car once again and wax it. It’s a permanent solution and gives your vehicle an original look.